1. the choice of stainless steel sanitary self-priming pump will meet some problems, how to solve the problem is related to the work can be carried out smoothly. Common problems in stainless steel hygienic self-priming pump. Common problem solving in stainless steel sanitary self-priming pump

2., the first reason is that when stainless steel self priming pump is used to transport particulate matter without water absorption, if the self priming pump does not absorb water, it is usually because the suction pipe inside the pump is blocked. When the water pipe is blocked, it needs to be cleaned. In addition, the failure of the impeller will also cause the failure, the solution is to replace a model matching impeller. If the suction pipe is wrong, it will cause a non water failure. The solution is to change the steering.

3. stainless steel sanitary self-priming pump needs to do well after the use of self-priming pump, clean water pump for half an hour. More comprehensive cleaning should be done every other time.

4. reason two, power is too big if this fault will check four positions. The first is to check the filling of the filler. If the packing is too tight, the bolt needs to be loosely adjusted. Second to check the friction inside the pump, if the friction is obvious will cause the power is too large, the solution is to adjust the gap. Third check the bearing, if the bearing is broken, a new one needs to be replaced. Finally, it is necessary to check the volume of the pump, and it is necessary to mediate the operation of the pump when it is too large.

5. reason three, bearing heat problem is very serious, if long time fever may damage the bearing. First of all, check whether the lubrication work is done well, whether the lubricating oil is used more or less, will cause the bearing to be heated, so every time when using lubricating oil, it is necessary to have some right amount. The second is to check whether there is no sundries in the lubricating oil, and it is not the sundries that increase the friction. If the bearing is already broken, a new one is needed.

• Print
• Close This Page
• Recommendation：
• 
• Browse：